I finished my RX Ensemble II Software Defined Radio. Here I am playing around with Winrad and my TS-2000. I am using Ham Radio Deluxe to tie the two together.

This is a short presentation video for the old version (0.3). Some features: – Connect to a Ham Radio Deluxe console over the network; – Directly connect to …
Video Rating: 4 / 5

30 replies
  1. florin eusebio
    florin eusebio says:

    buna ziua domnule toma, dar cum comunica tableta cu statia? interesant
    programul. eu am ambele echipamente, numai ca statia nu are ssb, dar am
    deschis canalele de frecvente de la 25 pana la 30mhz, cum as putea face un
    hamtransceiver via internet?

    Reply
  2. Milos Minic
    Milos Minic says:

    Hi Dan. first thank you very much for great app for us hams. Only have one
    trouble. How to connect remotely to HRD? When i enter ip adress and try to
    connect, program says that is connected to HRD, but never asking me for my
    username and password. In HRD remote log saw disconnect message. User and
    pass entering in cfg file in app?

    73 de Milos YU6MM

    Reply
  3. Josip Bedenicec
    Josip Bedenicec says:

    Thank you I am downloading document my best regards.whether it will work
    well with FT100d I hope he also has an 8 pin mini AND CAT control that
    would be very nice to work from portable locations

    Reply
  4. George LaBelle
    George LaBelle says:

    I don’t understand the point of this?! You are simply using the knob of the
    TS-2000 to tune the Ensemble. What’s wrong with using the mouse? You could
    easily add a USB “knob” (Griffin Technologies) that would allow you to tune
    the Ensemble without using an expensive radio. NOW, if you could switch the
    antenna back and forth between rigs, you could find stations with the
    Ensemble and work ’em with the Kenwood. (protect the frontend of the
    Ensemble). I plan to use the Ensemble as T2K panascope.

    Reply
  5. NOBama Nation
    NOBama Nation says:

    Which version of WinRad did you use? There’s 12 different receiver
    applications available. Does it matter which one?

    Reply
  6. gordonschlag
    gordonschlag says:

    George I use almost the same setup with the griffin the difference is i use
    power sdr-if you can use the mouse wheel in power sdr-if or hrd or the vfo
    knob. you don’t tune the ensemble it is set to one freq. in my case I set
    it to 10.723 mhz. you are tuning the radio not the sdr.

    Reply
  7. gordonschlag
    gordonschlag says:

    Oh I forgot you are not xmiting in to the ensemble you are just tuning into
    the if-freq and use the sdr as a panascope and in that configuration I turn
    the volume down on the 2000 and listen to the sdr through the computer, and
    it is more sensitive the the 2000 is.

    Reply

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.