Posts
RTL-SDR, FM+DAB, DVB-T USB Stick Set with RTL2832U & R820T. Great SDR for SDR#, HDSDR, and Other Popular SDR Software Packages!
- Included RTL2832U and R820T tuner ICs on the USB deviceRTL2832U
- Will work for both for software defined radio and DVB video capture (where available)
- Compatible with most SDR software, including SDR#. Provides an approximate tuning range of 25MHz-1700MHz for software defined radio (SDR)
DVB USB stick set with an R820T tuner IC. MCX input on the USB stick.
List Price: $ 12.95
Price: [wpramaprice asin=”B00C37AZXK”]
[wpramareviews asin=”B00C37AZXK”]
NooElec TV28T v2 USB DVB-T & RTL-SDR Receiver, RTL2832U & R820T Tuner, MCX Input. Low-Cost Software Defined Radio Compatible with Many SDR Software Packages. R820T Tuner & ESD-Safe Antenna Input, Guaranteed
- Included: NooElec USB dongle, antenna, remote control
- RTL2832U interface IC & R820T tuner IC on USB dongle
- Compatibility with SDR software packages
- Software may be downloaded freely from nooelec.com
- All purchases from NooElec include installation support if needed
These DVB-T dongles have new-found popularity since it was discovered they can be used as very inexpensive software defined radios.
These units are based on the R820T tuner IC made by Rafael Mirco. There is also an RTL2832U IC on board of course, which allows for interfacing to a large number of popular SDR software packages.
The connector type on the antenna and USB board is MCX.
List Price: $ 19.95
Price: [wpramaprice asin=”B009U7WZCA”]
[wpramareviews asin=”B009U7WZCA”]
Demonstration of my low-cost HF ham bands RTL-SDR USB dongle based Software-Defined-Receiver on 40 meter SSB and CW. Using a HomeBrew SA612 Upconverter along…
See new video: https://www.youtube.com/watch?v=qGMXG8e70-M Extra fine tuning steps: ***There is a new version of unitrunker, a preview build that allows you …
RTL-SDR + SDR# in direct sampling mode and MixW32 decoding RTTY on 147 kHz. No downconverter plugged in. Wire is directly soldered to pin 1 of RTL2832.
Video Rating: 0 / 5
1st attempt with signal present fails- Indicator in lower left shows “LISTEN CHANNEL”, then immediately fails with “STOPPING” due to busy channel detection. Cut back on RF gain so no signal is present. Transmits after “LISTEN CHANNEL” with “CALLING” indicator Third attempt with signal again fails immediately after LISTEN CHANNEL
Testing a Logilink VG0002A with SDR# and a retractable antenna (need something better).