Check out these ARRL images:
Installation of Jin Pole
Image by GraceFamily
ARRL Field Day Sunday June 29 , 2014 at the Reagan Library and Museum
Posts
I have rewired the CAT 200B to plug into either of our two Icom FR 3000 repeaters.
Here is a vid showing the installation of the backup at Saddle so we can do some service work on the 300.
Video Rating: 1 / 5
First tip-up of what will soon be a 55′ bracketed tower with a Mosley TA-53M and a 2m/440 vertical installation. We stood up a 25 foot section in order to al…
Video Rating: 5 / 5
I had to raise it but without the antenna because I’m having obstructing limbs cut down for clearance of the arch radius. I had to get the tower out of the w…
Video Rating: 3 / 5
Extra heavy duty 60 feet/18m, 2.5m2/32 sq ft wind load rating, aluminum self supporting motorized crank up/tilt over tower. This will carry a HF multiband ya…
This is the results of my first attempt at installing an amateur radio antenna. The G5RV is a 102′ wire flat top antenna with support for all the HF bands us…
Video Rating: 5 / 5
Antenna Directional Coupler Johnson SWR measuring – antenna matching http://www.fairs.org http://www.floydfolks.org Davids videos – antenna tuners https://ww…
Video Rating: 5 / 5
MY MOBILE HF INSTALLATION.
Video Rating: 0 / 5
Referencia: DEF021F- (Diploma Estaciones Ferroviarias) – (Informe RCA LU4AA – DEF021F) Activación realizada los días: 18-19 de ABRIL. Señal distintiva: LU7FJ…
Video Rating: 5 / 5
The Amateur Radio on the International Space Station (ARISS) program is hoping its “Ham Video” digital television transmitter, now stowed onboard the International Space Station (ISS), will be installed and commissioned this fall. US Astronaut Mike Hopkins, KF5LJG, who heads into space September 25, is scheduled to handle the tasks involved with getting the S Band Ham Video DATV setup on the ai…
American Radio Relay League | Ham Radio Association and Resources
HF Antenna Connection for Installation – Antennenadapter – I-PEX (M)
List Price: $ 30.14
Price: [wpramaprice asin=”B009ZL8HVY”]
[wpramareviews asin=”B009ZL8HVY”]
I dug holes 28″ deep through soil and clay, then positioned concrete cylinders. Sequentially I then tapped each 3 foot long 3/4″-10 threaded dowel into the bottom of the hole surface in relation to each corresponding hole on the hinge plate. Once all threaded dowels were established, I poured quickcrete into each cylinder to the brim. I joined all four of the inner exposed concrete forms by digging a pit in the center and filling it too with concrete. After the concrete solidified, I mounted the hinge plate on the foundation. I actually screwed on some 3/4″ nuts n each threaded dowel so that I could manually adjust the height of each corner should there be any mistake (inevitably there was). I placed the bottom tower section on the hinge plate and secured it with provided screws on the hinge brackets.
In September 2010, Paul Isaacs, W2JGQ, of New York City, obtained a building permit for his Amateur Radio antenna support structure, comprised of a 40 foot tower topped by a Yagi antenna. Isaacs installed his antenna system on the roof of his four story brownstone — 58 feet above ground — in lower Manhattan.
Almost four months later — months after the erection of the system — the New York Ci…
American Radio Relay League | Ham Radio Association and Resources
more on: video.qrz.pl
ICOM 746 PRO REPAIR PART 3 REPLACING CRYSTAL OSCILLATOR AND RETUNE ELECTRONICS REPAIR.
Video Rating: 5 / 5
Installing a 30 foot Rohn 25G tower at the qth of 9Y4NG-Arnold …. Installation is done without a gin pole , as the 10ft section is light ( pse think twice before installing this way ) …….. Cecil – 9Z4CLN is in the orange coverall , and Arnold – 9Y4NG is the videographer . After receiving emails from guys who are not into installing towers, I must say — YES that I do have 2 Gin Poles , I have been installing towers for yearssssss. I have the physical strength and a lot of learnt techniques for doing an installation this way …… ROHN 25G sections are very light for me to manage this way by myself ……… I have installed a 50ft and a 40ft tower with this method.. If you must try this , practice on the ground with a 10ft section to get used to the sections weight .
The Fresno Amatuer Radio Club 2008 Field Day held at Pineridge School in Pineridge California, elevation 4843 feet. This is the raising of a portable 75 foot tower.
Video Rating: 4 / 5
This video shows the teamwork of a ham radio (amateur radio) group in Brazil, to put in the air the new tower in the PY2RMI House. It was a great opportunity to get everybody together. In the video you can see the construction of the towers base, the assembling of the tower and the antenna installation. Tks all !!! Este vídeo mostra o time de Radio Amadores de Valinhos instalando a nova torre de PY2RMI na cidade de Valinhos SP, Obrigado a todos !!! Radio amador, radioamador PY
yes, i am aware that its dark. but this was a fun project. i wish i had gotten more footage than just the final product, but my hands were full helping him out. if you love amateur radio, this video is your heaven.
Video Rating: 4 / 5