Yaesu FT-950 listening on 40m Band

Does your FT-950 seem as sharp as this when tuning around? If not, perhaps you should try fitting the 3KHz replacement filter from Network Sciences, marketed…

11 replies
  1. joseph kopeczy
    joseph kopeczy says:

    i got my yaesu ft 950 all it has is nothing but intermitting problem yaesu could not find the problem it started 6 month after i got it new the whole started when i started use the eq setting now it out of warrenty the radio went from tx to rx then back to tx and no out put one the watt meter some of yaesu radio no good they know it i got screw buy my yaesu ft 950 other ham are have problem also the worse ham radio to buy

    Reply
  2. Michael Parker
    Michael Parker says:

    It is quite a built up area, but in fairness I would have had the RF gain turned back a bit to keep the hiss down 🙂

    Reply
  3. Michael Parker
    Michael Parker says:

    Hi, there are quite a few 10m radios, but I haven’t used any since my CB days, so am completely out of touch. To listen, try 28.300 through 28.500 for lots of SSB calling.

    Reply
  4. Bellwolfrace
    Bellwolfrace says:

    Difficult to see with the low light level, but it looks like the 950 has got the VFO dial upgrade kit on it ? If so, how do you find it over the standard VFO ?

    Reply

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.